Service Manual

router ospf
To configure an OSPF instance, enter ROUTER OSPF mode.
S4048–ON
Syntax
router ospf process-id
To clear an OSPF instance, use the no router ospf process-id command.
Parameters
process-id Enter a number for the OSPF instance. The range is from 1 to 65535.
Defaults Not configured.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
9.1(0.0) Added support for OSPFv3 on the S4810 and Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Added support for Multi-Process OSPF.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre- 6.1.1.1 Introduced on the E-Series.
Usage
Information
You must have an IP address assigned to an interface to enter ROUTER OSPF mode and configure OSPF.
Example
Dell(conf)# router ospf 2
Dell(conf-router_ospf)#
show config
Display the non-default values in the current OSPF configuration.
S4048–ON
Syntax
show config
Command Modes ROUTER OSPF
Open Shortest Path First (OSPFv2 and OSPFv3) 1005