Service Manual

show ipv6 flowlabel-zero
Display the flow label zero setting.
Syntax
show ipv6 flowlabel-zero
Default Disabled
Command Modes EXEC
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
Related
Commands
ipv6 nd dad attempts — Configure system to set the flow label field in the packets
to zero.
show ipv6 interface
Display the status of interfaces configured for IPv6.
Syntax
show ipv6 interface interface [brief] [configured] [loopback
interface-number] [managementethernet slot/port] [port-channel
number] [stack-unit id] [tengigabitethernet slot | slot/port[/
subport]] [fortyGigE slot | slot/port] [tunnel tunnel-id] [vlan
vlan-id]
Parameters
interface (OPTIONAL) Enter the following keywords and slot/port or
number information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port[/subport]
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
IPv6 Basics
985