Service Manual

specified percentage of the limit, a warning message is
generated. Valid range is 1 to 100. When warn-threshold is
used, once the limit is reached, additional routes will not be
allowed into the RTM ( route table manager ) itself.
warning-only When the warning-only option is used, a syslog message
will be thrown when maximum number of dynamic IPv6
routes reaches the limit. Additional dynamic IPv6 routes will
still be allowed.
Defaults No limit is set on the maximum number of dynamic IPv6 routes for a VRF.
Command Modes CONFIGURATION-VRF
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OSCommand Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S4810, S4820T, S5000, S6000, S6000-
ON, and Z9500.
Usage Information
If the maximum IPv6 route limit is not specified for a VRF (valid range is from 1 to
8000), then it has unlimited space that extends to the maximum number of entries
allowed for the system. This command is not applicable to the default and
management VRFs.
ipv6 address autoconfig
Configure IPv6 address auto-configuration for the management interface.
Syntax
ipv6 address autoconfig
To disable the address autoconfig operation on the management interface, use the
no ipv6 address autoconfig command.
Default Disabled
Command Modes INTERFACE (management interface only)
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
968
IPv6 Basics