Service Manual

Version Description
7.4.1.0 Introduced on the E-Series TeraScale.
clear ipv6 mld_host
Clear the IPv6 MLD host counters and reset the elapsed time.
Syntax
clear ipv6 mld_host
Command Modes EXEC
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
maximum dynamic-routes-ipv6
Specify the maximum number of dynamic (protocol) IPv6 routes a VRF can have.
Syntax maximum dynamic-routes—ipv6 limit {warn-threshold threshold-value
| warning-only}
To remove the limit on the maximum number of IPv6 routes used, use the no
maximum dynamic-routes-ipv6 command.
Parameters
limit Maximum number of IPv6 routes allowed in a VRF. Valid
range is from 1 to 8000 (or maximum allowable for that
platform if smaller value).
warning-
threshold
Warning threshold value is expressed as a percentage of the
limit value. When the number of IPv6 routes reaches the
IPv6 Basics
967