Service Manual

show tcp statistics
View information on TCP traffic through the switch.
Syntax
show tcp statistics {all | cp | rp1 | rp2}
Parameters
all Enter the keyword all to view all TCP information.
cp Enter the keyword cp to view only TCP information from
the Control Processor.
rp1 Enter the keyword rp1 to view only TCP statistics from
Route Processor 1.
rp2 Enter the keyword rp2 to view only TCP statistics from
Route Processor 2.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
6.4.1.0 Introduced
Usage Information The following describes the show tcp statistics cp command shown in the
following example.
Field Description
Rcvd: Displays the number and types of TCP packets received by
the switch.
• Total = total packets received
• no port = number of packets received with no
designated port
0 checksum
error...
Displays the number of packets received with the following:
• checksum errors
952
IPv4 Routing