Service Manual

Field Description
• E2 = OSPF external type 2
• i = IS-IS
• L1 = IS-IS level-1
• L2 = IS-IS level-2
• IA = IS-IS inter-area
• * = candidate default
• > = non-active route
• + = summary routes
Destination Identifies the route’s destination IP address
Gateway Identifies whether the route is directly connected and on which interface the
route is configured.
Dist/Metric Identifies if the route has a specified distance or metric.
Last Change Identifies when the route was last changed or configured.
The weight for weighted ECMP route calculations is displayed for each path in the route in show ip
route
command. The ECMP weight is displayed only if weighted ECMP is enabled using the ip
ecmp weighted
command is enabled.
If weighted ECMP is disabled, the show ip route command does not show the weighted ECMP
route information.
Example
Dell#show ip route all
Codes:C- connected, S - static, R - RIP
B- BGP, IN - internal BGP, EX - external BGP, LO - Locally Originated
O- OSPF, IA - OSPF inter area N1 - OSPF NSSA external type 1
N2- OSPF NSSA external type 2, E1 - OSPF external type 1
E2- OSPF external type 2, i - IS-IS, L1 - IS-IS level-1
L2- IS-IS level-2, IA - IS-IS inter area, * - candidate default
>- non-active route + - summary route
Gateway of last resort is not set
Destination Gateway Dist/Metric Last Change
----------- ------- ----------- -----------
R 3.0.0.0/8 via 100.10.10.10, Te 2/8 120/1 00:07:12
via 101.10.10.10, Te 2/9
100.10.10.0/24 Direct, Te 2/8 0/0 00:08:54
> R 100.10.10.0/24 Direct, Te 2/8 120/0 00:08:54
C 101.10.10.0/24 Direct, Te 2/9 0/0 00:09:15
> R 101.10.10.0/24 Direct, Te 2/9 120/0 00:09:15
Dell#
Example
(Summary)
Dell#show ip route summary
Route Source Active Routes Non-active Routes
connected 2 0
static 1 0
Total 3 0
Total 3 active route(s) using 612 bytes
944
IPv4 Routing