Dell PowerSwitch S4048-ON : Service Manual : Page 92

tftp: Copy from remote file system (tftp://hostip/filepath)

Dell# upgrade system ftp://username:password@10.11.1.1/FTOS-SB-7.7.1.0.bin

!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

!!!!!!!!!!!!!!!!!!!!!!

Erasing Sseries ImageUpgrade Table of Contents, please wait

.!..................................................................................................

....................................................................................................

....................................!

12946259 bytes successfully copied

Dell# reload

upgrade system

Upgrade the Dell Networking OS image. To upgrade the bootflash or bootselector image, use the

upgrade boot command.

Syntax

upgrade system {flash: | ftp: | nfsmount: | scp: | stack-unit {stack-unit-id | all} | tftp: | usbflash:} file-url {A: |B:}

Parameters

system Enter the keyword system to upgrade the operating system (OS) image.

flash: file-url Enter the keyword flash: and specify the location of the image file in the format //directory-path or press Enter to launch a prompt sequence.

ftp: file-url Enter the keyword ftp: and specify the location of the image file in the format //userid:password@host-ip/filepath or press Enter to launch a prompt sequence.

nfsmount://

<mount-point>/

filepath

Enter the keyword nfsmount: and specify the location of the image file in the format //<mount-point>/filepath.

scp: file-url Enter the keyword scp: and specify the location of the image file in the format userid:password@host-ip/filepath or press Enter to launch a prompt sequence.

stack-unit stack-

unit-id

Enter the keyword stack-unit and specify the stack-unit ID to sync the image to that stack-unit.

stack-unit all Enter the keyword stack-unit followed by the keyword all to sync the image on all stack-units.

tftp: file-url Enter the keyword tftp: and specify the location of the image file in the format //host-ip/filepath or press Enter to launch a prompt sequence.

usbflash: file-url Enter the keyword usbflash: and specify the location of the source file in the format //directory-path to upgrade form an external flash device or press Enter to launch a prompt sequence.

A: | B: Specify the flash partition of the operating-system image to be upgraded.

Defaults none

Command Modes EXEC Privilege

92

File Management