Service Manual
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port[/subport]
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a Loopback interface, enter the keyword loopback
then a number from 0 to 16383.
• For the Management interface on the stack-unit, enter
the keyword ManagementEthernet then the slot/port
information.
The slot range is from 1 to 11. The port
range is 1.
• For a port channel interface, enter the keywords port-
channel then a number.
• For a Null interface, enter the keyword null then the Null
interface number.
• For a VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
• For a tunnel interface, enter the keyword tunnel then the
tunnel interface number. The range is from 1 to 16383.
If you configure a static IPv6 route using an egress interface
and enter the ping command to reach the destination IPv6
address, the ping operation may not work. Configure the
IPv6 route using a next-hop IPv6 address in order for the
ping command to detect the destination address.
interface ip-
address
Enter the keyword interface then the IP address.
distance (OPTIONAL) Enter the value of the distance metric assigned
to the route. The range is from 1 to 255.
permanent (OPTIONAL) Enter the keyword permanent to specify that
the route must not be removed even if the interface
assigned to that route goes down. The route must be
currently active to be installed in the routing table. If you
disable the interface, the route is removed from the routing
table.
tag tag-value (OPTIONAL) Enter the keyword tag then a number to assign
to the route. The range is from 1 to 4294967295.
vrf vrf-name Enter the keyword vrf followed by the name of the VRF.
Use this VRF option after the next hop to specify which VRF
the next hop belongs to. This setting is used in route leaking
cases. Refer to the Route Leaking VRFs section in the Virtual
Routing and Forwarding (VRF) chapter of the Configuration
guide.
weight weight-
value
Enter the keyword weight followed by a weight value. The
range is from 0 to 255.
IPv4 Routing
915