Service Manual

Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.4.(0.0) Introduced on the S4810 and S4820T.
Usage Information Use this command to specify the maximum number of ARP entries that the Route
Table Manager can hold for a specific VRF. This command does not apply to the
management VRFs.
arp retries
Set the number of ARP retries in case the system does not receive an ARP reply in response to an ARP
request.
Syntax
arp retries number
Parameters
number Enter the number of retries. The range is from 1 to 20. The
default is 5.
Defaults 5
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.3.1.0 Introduced.
Usage Information Retries are 20 seconds apart.
Related
Commands
show arp retries — displays the configured number of ARP retries.
IPv4 Routing
883