Service Manual

Usage Information This command creates a crypto policy entry and enters the crypto policy
configuration mode for configuring the flow parameters.
Example
Dell(conf)#crypto ipsec policy West 10 ipsec-manual
Dell(conf-crypto-policy)#
management crypto-policy
Apply the crypto policy to management traffic.
Syntax
management crypto-policy name
To remove the management traffic crypto policy, use the no management
crypto-policy name command.
Parameters
name Enter the name for the crypto policy..
Defaults none
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.2(0.2) Introduced on the Z9000, S4810, and S4820T.
match
Apply an match filter to the crypto policy.
Syntax
match seq-num tcp [sourceip address | ipv6 address {mask}
{source-port number}] [destination ip address | ipv6 address
{mask} {destination-port number}]
Internet Protocol Security (IPSec)
873