Service Manual

Enhanced Validation of Interface Ranges

This functionality is supported on the platform.

You can avoid specifying spaces between the range of interfaces, separated by commas, that you

configure by using the interface range command. For example, if you enter a list of interface ranges,

such as interface range fo 2/50-2,te 1/1, this configuration is considered valid. The comma-

separated list is not required to be separated by spaces in between the ranges. You can associate

multicast MAC or hardware addresses to an interface range and VLANs by using the

mac-address-

table static multicast-mac-address vlan vlan-id output-range interface command.

Enhanced Validation of Interface Ranges

869