Service Manual

Usage Information The interface must be enabled to run the test or an error message is generated:
Dell#tdr-cable-test tengigabitethernet 11/1
% Error: Interface is disabled Te 11/1.
Syslog messages are generated when the link flaps during TDR tests.
Related
Commands
show tdr — displays the results of the TDR test.
show tdr
Display the TDR test results.
Syntax
show tdr interface
Parameters
interface Enter the keyword TenGigabitEthernet then the slot/
port information for the 100/1000 Ethernet interface.
Defaults none
Command Modes EXEC
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7.0.0 Introduced on the S5000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Introduced on the E-Series ExaScale.
7.7.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
6.1.1.0 Introduced.
Usage Information If the TDR test has not been run, an error message is generated:
%Error: Please run the TDR test first
The following describes the TDR test status.
862
Interfaces