Service Manual

show config
Display the current configuration of the selected LAG.
Syntax
show config
Command Modes INTERFACE PORTCHANNEL
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-Version
6.2.1.0
Introduced on the E-Series.
Example
Dell(conf-if-po-1)#show config
!
interface Port-channel 1
no ip address
shutdown
Dell(conf-if-po-1)#
show interfaces port-channel
Display information on configured Port Channel groups.
Syntax
show interfaces port-channel [channel-number] [brief]
Parameters
channel-number For a Port Channel interface, enter the keyword port-
channel then a number. For the C-Series and S-Series, the
range is from 1 to 128.
brief (OPTIONAL) Enter the keyword brief to display only the
port channel number, the state of the port channel, and the
number of interfaces in the port channel.
Interfaces
855