Service Manual

interface range macro (define) — defines a macro for an interface range (bulk
configuration).
interface vlan
Configure a VLAN. You can configure up to 4094 VLANs.
Syntax
interface vlan vlan-id [of-instance{of-id}]
Parameters
of-instance{of-id} Enter the keyword of-instance then the OpenFlow instance
ID to add the VLAN to the specified OpenFlow instance. The
range is from 1 to 8.
NOTE: Associate the OpenFlow instance with the VLAN
when the VLAN is created. An existing VLAN cannot be
associated with an OpenFlow instance.
Defaults Not configured, except for the Default VLAN, which is configured as VLAN 1.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.0.2.0 Introduced on the S6000.
9.1.(0.0) Introduced on the S4810; added support for OpenFlow.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
Usage Information
For more information about VLANs and the commands to configure them, refer to
the Virtual LAN (VLAN) Commands section of the Layer 2 chapter.
FTP, TFTP, and SNMP operations are not supported on a VLAN. MAC ACLs are not
supported in VLANs. IP ACLs are supported. For more information, refer to the
Access Control Lists (ACL) chapter.
The following features are not supported on VLANs associated with an OpenFlow
instance:
• IPv4
• IPv6
798
Interfaces