Service Manual

Parameters
interface {slot/
port[subport] |
port} — {slot/
port[subport] |
port}, interface
{slot/port[subport]
| port} — {slot/
port[subport] |
port},...
Enter interface range and one of the interfaces and
then slot/port[/subport], port-channel, or VLAN number
information. Select the range of interfaces for bulk
configuration. You can enter up to six comma-separated
ranges. Spaces are not required between the commas. The
ranges can include VLANs, port-channels, and physical
interfaces.
• For a port channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port[/subport]
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
• For a Tunnel interface, enter the keyword Tunnel then a
number from 1 to 16383.
Defaults None
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
8.2.1.0 Added support for 4093 VLANs on E-Series ExaScale. Prior
releases supported 2094.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced on the E-Series.
Interfaces
793