Service Manual

Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.4.1.0 Introduced
Usage Information You cannot delete the Null interface. The only configuration command possible in
a Null interface is ip unreachables.
Example
Dell(conf)#interface null 0
Dell(conf-if-nu-0)#
Related
Commands
interface — configures a physical interface.
interface loopback — configures a Loopback interface.
interface port-channel — configures a port channel.
interface vlan — configures a VLAN.
ip unreachables — enables generation of internet control message protocol (ICMP)
unreachable messages.
interface range
This command permits configuration of a range of interfaces to which subsequent commands are
applied (bulk configuration). Using the interface range command, you can enter identical commands
for a range of interface.
Syntax
interface range interface {slot/port[subport] | port} — {slot/
port[subport] | port}, interface {slot/port[subport] | port} —
{slot/port[subport] | port},...
792
Interfaces