Service Manual

Interfaces

The commands in this chapter are supported by Dell Networking operating software on the platform.

This chapter contains the following sections:

• Basic Interface Commands

• Port Channel Commands

• Time Domain Reflectometer (TDR)

• UDP Broadcast

Basic Interface Commands

The following commands are for Physical, Loopback, and Null interfaces.

clear counters

Clear the counters used in the show interfaces commands for all virtual router redundancy protocol

(VRRP) groups, virtual local area networks (VLANs), and physical interfaces, or selected ones.

Syntax

clear counters [interface] [vrrp [ipv6 {vrid} | learning-limit

| vlan vlan-id]

Parameters

interface (OPTIONAL) Enter any of the following keywords and slot/

port[/subport] or number to clear counters from a specified

interface:

• For IPv4 access-group counters, enter the keyword ip.

• For IPv6 access-group counters, enter the keyword

ipv6.

• For a Loopback interface, enter the keyword loopback

then a number from 0 to 16383.

• For MAC access-group counters, enter the keyword mac.

• For a Port Channel interface, enter the keywords port-

channel then a number. The range is from 1 to 128.

• For the management interface, enter the keyword

ManagementEthernet then slot/port information.

Interfaces

777