Service Manual

• For a file on the internal Flash, enter flash:// followed

by the filename.

• For a file on an NFS mounted file system, enter

nfsmount:// followed by the mount point and file

path.

• For a file on an external USB drive, enter usbflash://

followed by the filename.

Command Modes EXEC Privilege

Command History

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.8(0.0) Introduced on the S3048-ON and S4048-ON.

9.7(0.0) Introduced on the S6000-ON. Added support for NFS

mount.

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.7.0 Introduced on the S4810.

7.6.1.0 Introduced on S-Series

7.5.1.0 Introduced on C-Series

E-Series Original command

restore factory-defaults

Restore factory defaults.

Syntax

restore factory-defaults stack-unit {stack—unit—number | all}

{clear-all | bootvar | nvram}

Parameters

factory-defaults Return the system to its factory default mode.

stack-unit-

number

Enter the stack member unit identifier to restore only the

mentioned stack-unit. The range is from 1 to 6.

all Enter the keyword all to restore all units in the stack.

bootvar Enter the keyword bootvar to reset boot line.

File Management