Service Manual

Parameters
interface interface (OPTIONAL) Enter the keyword interface then one of the
interface keywords and slot/port[/subport] or number
information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port[/subport]
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a port channel interface, enter the keywords port-
channel
then a number. The range is from 1 to 128.
summary Enter the keyword summary to display just a summary of the
GVRP statistics.
Defaults none
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
8.3.11.1 Introduced on the Z9000.
7.6.1.0 Introduced on C-Series, E-Series, and S-Series
Usage Information Invalid messages/attributes skipped can occur in the following cases:
• The incoming GVRP PDU has an incorrect length.
• "End of PDU" was reached before the complete attribute could be parsed.
• The Attribute Type of the attribute that was being parsed was not the GVRP VID
Attribute Type (0x01).
• The attribute that was being parsed had an invalid attribute length.
• The attribute that was being parsed had an invalid GARP event.
• The attribute that was being parsed had an invalid VLAN ID. The valid range is
from 1 to 4095.
A failed registration can occur for the following reasons:
• Join requests were received on a port that was blocked from learning dynamic
VLANs (GVRP Blocking state).
GARP VLAN Registration (GVRP)
733