Service Manual

Version Description
9.0.0.0 Introduced on the Z9000.
8.3.10.0 Introduced on the S4810.
Usage Information You must save the new ECMP settings to the startup-config (write-mem) then
reload the system for the new settings to take effect.
Related
Commands
show ip cam stack-unit – Display content-addressable memory (CAM) entries for
an S-Series switch.
ip ecmp weighted
Enables weighted ECMP calculations.
Syntax
ip ecmp weighted
To disable weighted ECMP calculations, enter the no ip ecmp weighted
command.
Defaults N/A
Command Modes CONFIGURATION
Command History
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S-Series.
Usage Information
Enabling this CLI would inform the FIB to re-program the destination prefix paths
with weights in the HW/CAM on the fly.
If disabled, the CLI would inform the FIB to re-program the destination prefix paths
with no weights or regular ECMP.
Example
Dell(conf)#ip ecmp ?
weighted Enables Weighted ECMP
Dell(conf)#ip ecmp weighted
Dell(conf)#do show running-config | grep ecmp
ip ecmp weighted
Dell(conf)#
Dell(conf)#no ip ecmp ?
weighted Disables Weighted ECMP
Dell(conf)#no ip ecmp weighted
Dell(conf)#do show running-config | grep ecmp
682
Equal Cost Multi-Path (ECMP)