Service Manual

Version Description
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.3.1.0 Introduced on the E-Series.
7.8.1.0 Introduced on the C-Series and S-Series.
ipv6 dhcp snooping trust
Configure an interface as trusted for DHCP snooping.
Syntax
[no] ipv6 dhcp snooping trust
To disable dhcp snooping trusted capability on this interface, use the no ipv6
dhcp snooping trust command.
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S4810, S4820T, S6000 and Z-Series.
ip dhcp source-address-validation
Enable the IP Source Guard.
Syntax
[no] ip dhcp source-address-validation [ipmac] [vlan vlan-id]
Parameters
ipmac Enable IP+MAC Source Address Validation.
vlan vlan-id (OPTIONAL) SAV validates the source IP address along with
the source VLAN ID against the DHCP snooping binding
table.
Defaults Disabled
Command Modes
INTERFACE
INTERFACE PORTCHANNEL
Dynamic Host Configuration Protocol (DHCP)
661