Service Manual

DCBX Operational Version is 0
DCBX Max Version Supported is 0
Sequence Number: 2
Acknowledgment Number: 2
Protocol State: In-Sync
Peer DCBX Status:
----------------
DCBX Operational Version is 0
DCBX Max Version Supported is 255
Sequence Number: 2
Acknowledgment Number: 2
Total DCBX Frames transmitted 27
Total DCBX Frames received 6
Total DCBX Frame errors 0
Total DCBX Frames unrecognized 0
dcb-map
Create a DCB map to configure priority flow control (PFC) and enhanced transmission selection (ETS) on
Ethernet ports that support converged Ethernet traffic. Apply the DCB map to an Ethernet interface.
Syntax
dcb-map map-name
Parameters
map-name Enter a DCB map name. The maximum number of
alphanumeric characters is 32.
Defaults None. There are no pre-configured PFC and ETS settings on S5000 Ethernet
interfaces.
Command Modes CONFIGURATION
INTERFACE
Command History
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.3(0.0) Introduced on the S4810 and S6000 platforms.
Usage Information
A DCB map is a template used to configure DCB parameters and apply them on
converged Ethernet interfaces. DCB parameters include priority-based flow control
(PFC) and enhanced traffic selection (ETS).
To display the PFC and ETS settings in DCB maps, enter the show qos dcb-map
command.
Data Center Bridging (DCB)
587