Service Manual

Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.16.0 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
dot1p priority traffic on the switch is scheduled to the current queue mapping.
dot1p priorities within the same queue must have the same traffic properties and
scheduling method.
ETS-assigned scheduling applies only to data queues, not to control queues.
The configuration of bandwidth allocation and strict-queue scheduling is not
supported at the same time for a priority group. If you configure both, the
configured bandwidth allocation is ignored for priority-group traffic when you
apply the output policy on an interface.
If you enable this command for a QoS ETS output policy, no bandwidth percentage
is assigned to the policy.
Related
Commands
• qos-policy-output ets — configures the ETS bandwidth allocation.
• bandwidth-percentage — bandwidth percentage allocated to priority traffic in
port queues.
show interface ets
Displays the ETS configuration applied to egress traffic on an interface, including priority groups with
priorities and bandwidth allocation.
Syntax
show interface port-type slot/port[/subport] ets {summary |
detail}
Parameters
port-type slot/
port[/subport] ets
Enter the port-type slot and port ETS information. Enter the
subport number if a 40G port is fanned-out into 10G ports.
{summary | detail} Enter the keyword summary for a summary list of results or
enter the keyword detail for a full list of results.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
Data Center Bridging (DCB)
571