Service Manual

Command Modes CONFIGURATION

Command History

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.8(0.0) Introduced on the S3048-ON and S4048-ON.

9.7(0.0) Introduced on the S6000–ON.

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.7.0 Introduced on the S4810.

8.2.1.0 Introduced on the S-Series.

7.8.1.0 Introduced on the C-Series.

Usage Information When you enable this command, if a Policy Map containing classification rules (ACL

and/or dscp/ ip-precedence rules) is applied to more than one physical interface

on the same port pipe, only a single copy of the policy is written (only one FP entry

is used).

NOTE: An ACL itself may still require more that a single FP entry, regardless of

the number of interfaces. For more information, refer to the “IP Access

Control Lists”, “Prefix Lists”, and “Route-map” sections in the Dell Networking

OS Configuration Guide.

show cam-acl

Display the details of the CAM profiles on the chassis and all stack units.

Syntax