Service Manual

number ecfmacl
number
{nlbclusteracl]
[vman-qos |
vman-dual-qos
number] ipv4pbr
numberopenflow
{4|8} | fcoe
number
[iscsioptacl
number] [vrfv4acl
number]
• 8: Creates 498 entries for use by the OpenFlow
controller (512 total entries minus the 14 entries reserved
for internal functionality)
The fcoe range is 0–6 groups. Each group has 128 entries;
the value given must be an even number. This information is
stored in the NVRAM and is effective after rebooting the
switch.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Added the nlbcluster ACL keyword. Introduced on the
S6000-ON.
9.4.(0.0) Added support for PBR and VRF.
9.2(0.2) Added support for fcoe.
9.1.(0.0) Added support for OpenFlow.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.10.2 Clarified block information for the S4810.
8.3.10.0 Introduced on the S4810.
8.3.1.0 Added the keywords ecfmacl, vman-qos, and vman-
dual-qos.
8.2.1.0 Introduced on the S-Series.
7.8.1.0 Introduced on the C-Series.
Usage Information
Save the new CAM settings to the startup-config (write-mem or copy run
start) then reload the system for the new settings to take effect.
The total amount of space allowed is 16 FP Blocks. System flow requires three
blocks; these blocks cannot be reallocated. Only 13 number of blocks can be
configured by the user .
The ipv6acl allocation must be a factor of 2.
Content Addressable Memory (CAM)
539