Service Manual

l2qos number Enter the keyword l2qos and then the number of FP blocks
for l2 qos. The range is from 1to 8.
l2pt number Enter the keyword l2pt and then the number of FP blocks
for l2 protocol tunnelling. The range is from 0 to 1.
Ipmacacl number Enter the keyword ipmacacl and then the number of FP
blocks for IP and MAC ACL. The range is from 0 to 6.
ecfmacl number Enter the keyword ecfmacacl and then the number of FP
blocks for ECFM ACL. The range is from 0 to 5.
nlbclusteracl
number
Enter the keyword nlbclusteracl and then the number of
FP blocks for nlbcluster ACL. The range is from 0 to 2. By
default the value is 0 and it supports 8 NLB arp entries
reserved for internal functionality.
NOTE: When you reconfigure CAM allocation, use the
nlbclusteracl number command to change the
number of NLB ARP entries. The range is from 0 to 2.
The default value is 0. At the default value of 0, eight
NLB ARP entries are available for use. This platform
supports up to 512 CAM entries. Select 1 to configure
256 entries. Select 2 to configure 512 entries. Even
though you can perform CAM carving to allocate the
maximum number of NLB entries, Dell Networking
recommends that you use a maximum of 64 NLB ARP
entries.
Vman-qos|vman-
dual-qos number
Enter the keyword evman-qos and then the number of FP
blocks for VMAN QoS. The range is from 0 to 6.
vman-dual-qos
number
Enter the keyword vman-dual-qos and then the number of
FP blocks for VMAN dual QoS. The range is from 0 to 4.
Ipv4pbr number Enter the keyword ipv4pbr and then the number of FP
blocks for ipv4pbr ACL. The range is from 0 to 8.
Openflow number Enter the keyword openflow and then the number of FP
blocks for open flow (multiples of 4). The range is from 0 to
8.
fcoeacl number Enter the keyword fcoeacl and then the number of FP
blocks for FCOE ACL. The range is from 0 to 6.
Iscsioptacl
number
Enter the keyword iscsioptacl and then the number of
FP blocks for iSCSI optimization ACL. The range is from 0 to
2.
l2acl number
ipv4acl number
ipv6acl number,
ipv4qos number
l2qos numberl2pt
number ipmacacl
Allocate space to each CAM region.
Enter 4 or 8 for the number of OpenFlow FP blocks.
• 4: Creates 242 entries for use by the OpenFlow
controller (256 total entries minus the 14 entries
reserved for internal functionality)
538
Content Addressable Memory (CAM)