Service Manual

peer-group-name (OPTIONAL) Enter the name of a peer group to view
information about that peer group only.
detail (OPTIONAL) Enter the keyword detail to view detailed
status information of the peers in that peer group.
summary (OPTIONAL) Enter the keyword summary to view status
information of the peers in that peer group. The output is
the same as that found in the show ip bgp summary
command.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048–ON and S4048–ON.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.8.0 Added the add-path option to the S4810. Output on the
S4810 shows the ADDPATH parameters.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage Information
The following describes the show ip bgp peer-group command shown in the
following example.
Line beginning
with:
Description
Peer-group Displays the peer group’s name.
Administratively
shut
Displays the peer group’s status if the peer group is not
enabled. If you enable the peer group, this line is not
displayed.
BGP version Displays the BGP version supported.
Minimum time Displays the time interval between BGP advertisements.
For address family Displays IPv4 Unicast as the address family.
BGP neighbor Displays the name of the BGP neighbor.
514
Border Gateway Protocol