Service Manual

Version Description
7.7.1.0 Introduced on the C-Series.
Usage Information
The following describes the show ip bgp paths community command shown
in the following example.
Field Description
Address Displays the internal address where the path attribute is
stored.
Hash Displays the hash bucket where the path attribute is stored.
Refcount Displays the number of BGP routes using these
communities.
Community Displays the community attributes in this BGP path.
Example
Dell#show ip bgp paths community
Total 2 communities
Refcount Community
1 NO-ADVERTISE
1 200:1 1000:1 3000:1
show ip bgp peer-group
Allows you to view information on the BGP peers in a peer group.
Syntax
show ip bgp [vrf vrf-name] [ipv4 {multicast | unicast} | ipv6
unicast] peer-group [peer-group-name [detail | summary]]
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf to view information on
BGP peers in a peer group corresponding to that VRF.
NOTE: You can use this attribute to view information on
BGP peers in a peer group that correspond to either a
default or a non-default VRF.
ipv4 multicast (OPTIONAL) Enter the keyword ipv4 followed by the
keyword multicast to view information related only to
ipv4 multicast routes.
ipv4 unicast (OPTIONAL) Enter the keyword ipv4 followed by the
keyword unicast to view information related only to ipv4
unicast routes.
ipv6 unicast (OPTIONAL) Enter the keyword ipv6 followed by the
keyword unicast to view information related only to ipv6
unicast routes.
Border Gateway Protocol
513