Service Manual

Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048–ON and S4048–ON.
9.7(0.0) Added the ipv4 multicast and ipv6 unicast parameters.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage Information
The following describes the show ip bgp flap command shown in the
following example.
Field Description
Network Displays the network ID to which the route is flapping.
From Displays the IP address of the neighbor advertising the
flapping route.
Flaps Displays the number of times the route flapped.
Duration Displays the hours:minutes:seconds since the route first
flapped.
Reuse Displays the hours:minutes:seconds until the flapped route
is available.
Path Lists all the ASs the flapping route passed through to reach
the destination network.
Example
Dell#show ip bgp flap-statistics
BGP local RIB : Routes to be Added 0, Replaced 0, Withdrawn 0
BGP local router ID is 192.168.11.5
Status codes: s suppressed, S stale, d dampened, h history, *
valid, > best
Path source: I - internal, a - aggregate, c - confed-external,
r - redistributed
n - network, D - denied, S - stale
Origin codes: i - IGP, e - EGP, ? - incomplete
Network From Flaps
Duration Reuse Path
h 77.0.0.0/24 172.16.0.2 1
00:00:03 00:00:00
d 55.0.0.0/24 172.16.0.2 3
502
Border Gateway Protocol