Service Manual

static
Enter the keyword static to redistribute manually
configured routes.
These routes are treated as incomplete routes.
route-map map-
name
(OPTIONAL) Enter the keyword route-map then the name
of an established route map.
Only the following ROUTE-MAP mode commands are
supported:
• match ip address
• set community
• set local-preference
• set metric
• set next-hop
• set origin
• set weight
If the route map is not configured, the default is deny (to
drop all routes).
Defaults Not configured.
Command Modes ROUTER BGP
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048–ON and S4048–ON.
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.3.1.0 Introduced the ability to substitute IGP cost for MED when a
peer/peer-group outbound route-map is set as internal.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
478
Border Gateway Protocol