Service Manual

Related
Commands
bgp four-octet-as-support — enables 4-byte support for the BGP process.
neighbor default-originate
Inject the default route to a BGP peer or neighbor.
Syntax
neighbor {ip-address | peer-group-name} default-originate
[route-map map-name]
To remove a default route, use the no neighbor {ip-address | peer-
group-name} default-originate command.
Parameters
ip-address (OPTIONAL) Enter the IP address of the neighbor in dotted
decimal format.
peer-group-name Enter the name of the peer group to set the default route of
all routers in that peer group.
route-map map-
name
(OPTIONAL) Enter the keyword route-map then the name
of a configured route map.
Defaults Not configured.
Command Modes ROUTER BGP
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048–ON and S4048–ON.
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage Information If you apply a route map to a BGP peer or neighbor with the neighbor default-
originate command configured, the software does not apply the set filters in the
route map to that BGP peer or neighbor.
Border Gateway Protocol
449