Service Manual

peer-group peer-
group-name
(OPTIONAL) Enter the keyword peer-group followed by
the name of the peer group.
in (OPTIONAL) Enter the keyword in to view only BGP
updates received from neighbors.
out (OPTIONAL) Enter the keyword out to view only BGP
updates sent to neighbors.
prefix-list prefix-
list-name
(OPTIONAL) Enter the keyword prefix-list then the
name of an established prefix list. If the prefix list is not
configured, the default is permit (to allow all routes).
ip-address (OPTIONAL) Enter the IP address of the neighbor in dotted
decimal format.
peer-group-name (OPTIONAL) Enter the name of the peer group to disable or
enable all routers within the peer group.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048–ON and S4048–ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage Information
To remove all configured debug commands for BGP, enter the no debug ip bgp
command.
default-metric
Allows you to change the metric of redistributed routes to locally originated routes. Use this command
with the redistribute command.
Syntax
default-metric number
To return to the default setting, use the no default-metric command.
Border Gateway Protocol
441