Service Manual

in (OPTIONAL) Enter the keyword in to view BGP notifications
received from neighbors.
out (OPTIONAL) Enter the keyword out to view BGP
notifications sent to neighbors
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048–ON and S4048–ON.
9.7(0.0) Added ipv6 support.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage Information
To remove all configured debug commands for BGP, enter the no debug ip bgp
command.
debug ip bgp soft-reconfiguration
Enable soft-reconfiguration debug.
Syntax
debug ip bgp [vrf vrf-name] [A.B.C.D | X:X:X:X::X | peer-group-
name] soft-reconfiguration
To disable, use the debug ip bgp [vrf vrf-name] [A.B.C.D |
X:X:X:X::X | peer-group-name] soft-reconfiguration command.
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of
the VRF to enable soft-reconfiguration debugging on that
VRF.
A.B.C.D (OPTIONAL) Enter the IPv4 address of the neighbor in
dotted decimal format.
X:X:X:X::X (OPTIONAL) Enter an IPv6 address.
Border Gateway Protocol
439