Service Manual

out (OPTIONAL) Enter the keyword out to view only outbound
keepalive messages.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048–ON and S4048–ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage Information
To remove all configured debug commands for BGP, enter the no debug ip bgp
command.
debug ip bgp notifications
Allows you to view information about BGP notifications received from neighbors.
Syntax
debug ip bgp [vrf vrf-name] [A.B.C.D | X:X:X:X::X | peer-group
peer-group-name] notifications [in | out]
To disable debugging, use the no debug ip bgp [vrf vrf-name] [A.B.C.D
| X:X:X:X::X | peer-group peer-group-name] notifications [in |
out] command.
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name
of the VRF to view neighbor BGP notification information
corresponding to that VRF.
A.B.C.D (OPTIONAL) Enter the IPv4 address of the neighbor.
X:X:X:X::X (OPTIONAL) Enter an IPv6 address.
peer-group peer-
group-name
(OPTIONAL) Enter the keyword peer-group then the name
of the peer group.
438
Border Gateway Protocol