Service Manual

show ip bgp flap-statistics — views the BGP flap statistics.
undebug all — disables all debugging operations.
clear ip bgp peer-group
Reset a peer-group’s BGP sessions.
Syntax
clear ip bgp [vrf vrf-name] peer-group peer-group-name [ipv4
[multicast | unicast] | ipv6 unicast] [soft {in | out}]
Parameters
vrf vrf-name Enter the keyword vrf and then the name of the VRF to
reset the peer group corresponding to that VRF.
NOTE: You can use this attribute on a specific VRF to
remove history routes corresponding to that VRF. You
can also use this attribute to return the suppressed
routes corresponding to a specific VRF to an active
state.
peer-group-name Enter the peer group name to reset the BGP sessions within
that peer group.
ipv4 multicast (OPTIONAL) Enter the keyword ipv4 followed by the
keyword multicast to reset ipv4 multicast routes.
ipv4 unicast (OPTIONAL) Enter the keyword ipv4 followed by the
keyword unicast to reset ipv4 unicast routes.
ipv6 unicast (OPTIONAL) Enter the keyword ipv6 followed by the
keyword unicast to reset ipv6 unicast routes.
soft (OPTIONAL) Enter the keyword soft to reset soft
configuration.
in Enter the keyword in to re-configure soft inbound updates.
out Enter the keyword out to re-configure soft outbound
updates.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048–ON and S4048–ON.
9.7(0.0) Added the ipv4 multicast and ipv6 unicast parameters.
432
Border Gateway Protocol