Service Manual

bgp recursive-bgp-next-hop

Enable next-hop resolution through other routes learned by BGP.

Syntax

bgp recursive-bgp-next-hop

To disable next-hop resolution, use the no bgp recursive-bgp-next-hop

command.

Defaults Enabled

Command Modes ROUTER BGP

Command History

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.8(0.0) Introduced on the S3048–ON and S4048–ON.

9.7(0.0) Introduced on the S6000–ON.

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.7.0 Introduced on the S4810.

7.8.1.0 Introduced on the S-Series.

7.7.1.0 Introduced on the C-Series.

7.2.1.0 Introduced.

Usage Information

This command is a knob to disable BGP next-hop resolution using BGP learned

routes. During the next-hop resolution, only the first route that the next-hop

resolves through is verified for the route’s protocol source and is checked if the

route is learned from BGP or not.

The clear ip bgp command is required for this command to take effect and to

keep the BGP database consistent. Execute the

clear ip bgp command right

after executing this command.

Commands

clear ip bgp — clears the ip bgp.

424

Border Gateway Protocol