Service Manual

bgp add-path

Allow the advertisement of multiple paths for the same address prefix without the new paths replacing

any previous ones.

Syntax

bgp add-path [send | receive | both] path-count

Parameters

send Enter the keyword send to indicate that the system sends

multiple paths to peers.

receive Enter the keyword receive to indicate that the system

accepts multiple paths from peers.

both Enter the keyword both to indicate that the system sends

and accepts multiple paths from peers.

path-count Enter the number paths supported. The range is from 2 to

64.

Defaults Disabled

Command Modes

• ROUTER BGP

• ROUTER BGP-address-family

Command History

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.8(0.0) Introduced on the S3048–ON and S4048–ON.

9.7(0.0) Introduced on the S6000–ON.

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.11.0 Introduced on the Z9000.

8.3.8.0 Introduced on the S4810.

Commands

neighbor add-path — specifies that this neighbor/peer group can send/receive

multiple path advertisements.

404

Border Gateway Protocol