Service Manual

bfd neighbor command or configured for the peer group to which a
neighbor belongs. The neighbors inherit only the global timer values
(configured with the bfd neighbor command).
You can only enable BFD for VRRP in INTERFACE command mode (vrrp bfd
all-neighbors).
Related
Commands
neighbor bfd disable — Explicitly disables a BFD session with a BGP neighbor or a
BGP peer group.
bfd disable
Disable BFD on an interface.
Syntax
bfd disable
Re-enable BFD using the no bfd disable command.
Defaults BFD is disabled by default.
Command Modes VRRP
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.2(0.2) Introduced on S4810.
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.2.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the C-Series.
7.5.1.0 Introduced on the E-Series.
386
Bidirectional Forwarding Detection (BFD)