Service Manual

To return to the default settings, use the no udf-tcam name seq number
command.
Parameters
name Enter the UDF ACL profile name, up to 64 characters.
number Enter the keyword seq then the sequence number of the
Udf-Tcam table. The range is from 1 to 512.
Defaults None
Command Modes CONFIGURATION
Example
Dell(conf)#udf-tcam ipnip seq 1
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S6000, Z9500, and S4048-ON.
deny (for Standard IP ACLs)
To drop packets with a certain IP address, configure a filter.
Syntax
deny {source | any | host {ip-address}}[count [byte]] [dscp
value] [order] [fragments] [log [interval minutes] [threshold-
in-msgs [count]] [monitor]
To remove this filter, you have two choices:
• Use the no seq sequence-number command if you know the filter’s
sequence number.
• Use the no deny {source [mask] | any | host ip-address}
command.
Parameters
log (OPTIONAL) Enter the keyword log to enable the triggering
of ACL log messages.
threshold-in msgs
count
(OPTIONAL) Enter the threshold-in-msgs keyword
followed by a value to indicate the maximum number of
ACL logs that can be generated, exceeding which the
generation of ACL logs is terminated. with the seq, permit,
or
deny commands. The threshold range is from 1 to 100.
Access Control Lists (ACL)
323