Service Manual

show config — displays the current UDF TCAM profile configuration.
permit ip
Associate the UDF in IP access-list.
Syntax
permit ip {source mask | any | host ip-address} {destination
mask | any | host ip-address} udf-pkt-format name udf-
qualifier-value name
To remove this filter, use the no seq sequence-number command.
Parameters
source Enter the IP address of the network or host from which the
packets were sent.
mask Enter a network mask in /prefix format (/x) or A.B.C.D. The
mask, when specified in A.B.C.D format, may be either
contiguous or noncontiguous.
any Enter the keyword any to specify that all routes are subject
to the filter.
host ip-address Enter the keyword host then the IP address to specify a
host IP address.
destination Enter the IP address of the network or host to which the
packets are sent.
udf-pkt-format
name
Enter the keywords udf-pkt-format then the UDF ACL
profile name.
udf-qualifier-
value name
Enter the keywords udf-qualifier-value then the UDF
qualifier value profile name.
Command Modes
CONFIGURATION-STANDARD-ACCESS-LIST mode
CONFIGURATION-EXTENDED-ACCESS-LIST mode
Example
Dell(config-ext-nacl)#permit ip any any udf-pkt-format ipinip
udf-qualifier-value ipnip_val1
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S6000, Z9500, and S4048-ON.
Related
Commands
ip access-list standard — configures a standard ACL.
320
Access Control Lists (ACL)