Service Manual

show config — displays the current UDF TCAM profile configuration.
match
Configure the packet type to match for which the UDF offset bytes have to be parsed.
Syntax
match l2ethertype ipv4 ipprotocol value vlantag tagStatus
To return to the default settings, use the no match l2ethertype ipv4
ipprotocol value vlantag tagStatus command.
Parameters
l2ethertype Enter the keyword l2ethertype to match the L2
Ethertype.
ipv4 Enter the keyword ipv4 to match the IPv4 packet.
ipprotocol value Enter the keyword ipprotocol then the option to match
the IPv4 protocol. The options are:
• IP protocol number. The range is from 0 to 255.
• icmp — Internet control message protocol.
• tcp — Transmission control protocol.
• udp — User datagram protocol.
vlantag tagStatus Enter the keyword vlantag then the option to match the
VLAN packet. The options are:
• any — Any VLAN packet.
• double-tagged — Double tagged VLAN packet.
• single-tagged — Single tagged VLAN packet.
• untagged — Untagged VLAN packet.
Defaults None
Command Modes CONFIGURATION-UDF TCAM
Example
Dell(conf-udf-tcam)#match l2ethertype ipv4 ipprotocol 4
vlantag any
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S6000, Z9500, and S4048-ON.
Related
Commands
udf-tcam — creates a context for UDF TCAM.
Access Control Lists (ACL)
319