Service Manual

To delete a BGP LOCAL_PREF attribute, use the no set local-preference
command.
Parameters
value Enter a number as the LOCAL_PREF attribute value. The
range is from 0 to 4294967295.
Defaults Not configured.
Command Modes ROUTE-MAP
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.0 Introduced on the E-Series.
Usage Information The set local-preference command changes the LOCAL_PREF attribute for
routes meeting the route map criteria. To change the LOCAL_PREF for all routes,
use the bgp default local-preference command.
Related
Commands
bgp default local-preference — changes the default LOCAL_PREF attribute for all
routes.
set metric
To assign a new metric to redistributed routes, configure a filter.
Syntax
set metric [+ | -] metric-value
To delete a setting, enter no set metric.
Parameters
+ (OPTIONAL) Enter + to add a metric-value to the
redistributed routes.
Access Control Lists (ACL)
305