Service Manual

Related
Commands
set level — specify the OSPF area for route redistribution.
set metric — specify the metric value assigned to redistributed routes.
set metric-type — specify the metric type assigned to redistributed routes.
set tag — specify the tag assigned to redistributed routes.
set comm-list delete
To remove the specified community list from the BGP route’s COMMUNITY attribute, configure a filter.
Syntax
set comm-list community-list-name delete
To insert the community list into the COMMUNITY attribute, use the no set
comm-list community-list-name delete command.
Parameters
community-list-
name
Enter the name of an established Community list, up to 140
characters.
Defaults Not configured.
Command Modes ROUTE-MAP
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.8.1.0 Increased the name string to accept up to 140 characters.
Prior to 7.8.1.0, names are up to 16 characters long.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.0 Introduced on the E-Series.
Access Control Lists (ACL)
301