Service Manual

Version Description
8.1.1.0 Introduced on the E-Series ExaScale.
7.8.1.0 Increased the name string to accept up to 140 characters.
Prior to 7.8.1.0, names are up to 16 characters long.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.0 Introduced on the E-Series.
Usage Information Use caution when you delete route maps because if you do not specify a sequence
number, all route maps with the same map-name are deleted when you use the no
route-map map-name command.
Example
Dell(conf)#route-map dempsey
Dell(config-route-map)#
Related
Commands
show config — displays the current configuration.
set as-path
To modify the AS path for border gateway protocol (BGP) routes, configure a filter.
Syntax
set as-path prepend as-number [... as-number]
To remove an AS-Path setting, use the no set as-path {prepend as-number
| tag} command.
Parameters
prepend as-
number
Enter the keyword prepend and then enter up to eight AS
numbers to be inserted into the BGP path information. The
range is from 1 to 65535.
Defaults Not configured.
Command Modes ROUTE-MAP
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
Access Control Lists (ACL)
299