Service Manual

match metric — redistributes routes that match a specific metric.
match route-type — redistributes routes that match a route type.
route-map
Enable a route map statement and configure its action and sequence number. This command also places
you in ROUTE-MAP mode.
Syntax
route-map map-name [permit | deny] [sequence-number]
To delete a route map, use the no route-map map-name [permit | deny]
[sequence-number] command.
Parameters
map-name Enter a text string of up to 140 characters to name the route
map for easy identification.
permit (OPTIONAL) Enter the keyword permit to set the route
map default as permit. If you do not specify a keyword, the
default is permit.
deny (OPTIONAL) Enter the keyword deny to set the route map
default as deny.
sequence-
number
(OPTIONAL) Enter a number to identify the route map for
editing and sequencing with other route maps. You are
prompted for a sequence number if there are multiple
instances of the route map. The range is from 1 to 65535.
Defaults Not configured.
If you do not define a keyword (permit or deny) for the route map, the permit
action is the default.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
298
Access Control Lists (ACL)