Service Manual

To delete a match, use the no match route-type {local | internal |
external [type-1 | type-2] | level-1 | level-2} command.
Parameters
external [type-1|
type-2]
Enter the keyword external then either type-1 or type-2
to match only on OSPF Type 1 routes or OSPF Type 2
routes.
internal Enter the keyword internal to match only on routes
generated within OSPF areas.
level-1 Enter the keyword level-1 to match IS-IS Level 1 routes.
level-2 Enter the keyword level-2 to match IS-IS Level 2 routes.
local Enter the keyword local to match only on routes
generated within the switch.
Defaults Not configured.
Command Modes ROUTE-MAP
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.0 Introduced on the E-Series.
Related
Commands
match interface — redistributes routes that match the next-hop interface.
match ip address — redistributes routes that match an IP address.
match ip next-hop — redistributes routes that match the next-hop IP address.
match ip route-source — redistributes routes that match routes advertised by other
routers.
296
Access Control Lists (ACL)