Service Manual

byte (OPTIONAL) Enter the keyword byte to count bytes
processed by the filter.
log (OPTIONAL, E-Series only) Enter the keyword log to log the
packets.
monitor (OPTIONAL) Enter the keyword monitor when the rule is
describing the traffic that you want to monitor and the ACL
in which you are creating the rule is applied to the
monitored interface. For more information, refer to the
“Flow-based Monitoring” section in the Port Monitoring
chapter of the Dell Networking OS Configuration Guide.
Defaults Not configured.
Command Modes CONFIGURATION-MAC ACCESS LIST-EXTENDED
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
7.4.1.0 Added the monitor option.
6.1.1.0 Introduced on the E-Series.
Usage Information
When you use the log option, the CP processor logs detail the packets that match.
Depending on how many packets match the log entry and at what rate, the CP
may become busy as it has to log these packets’ details.
NOTE: When you configure the ACL logging and byte counters
simultaneously, byte counters may display an incorrect value. Configure
packet counters with logging instead.
Related
Commands
permit — configures a MAC address filter to pass packets.
274
Access Control Lists (ACL)