Service Manual

Version Description
7.8.1.0 Increased the name string to accept up to 140 characters.
Prior to 7.8.1.0, names are up to 16 characters long.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced on the E-Series.
Usage Information You can assign one ACL (standard or extended) to an interface.
Related
Commands
mac access-list standard — configures a standard MAC ACL.
mac access-list extended — configures an extended MAC ACL.
show mac access-lists
Display all of the Layer 2 ACLs configured in the system, whether or not they are applied to an interface,
and the count of matches/mismatches against each ACL entry displayed.
Syntax
show mac access-lists [access-list-name] [interface interface]
[in | out]
Parameters
access-list-name Enter the name of a configured MAC ACL, up to 140
characters.
interface interface Enter the keyword interface then the one of the
following keywords and slot/port[/subport] or number
information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port[/subport]
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
in | out Identify whether ACL is applied on ingress or egress side.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000–ON.
264
Access Control Lists (ACL)