Service Manual

Parameters
access-list-name Enter the name of a configured MAC access list, up to 140
characters.
vlan vlan-range (OPTIONAL) Enter the keyword vlan and then enter a range
of VLANs. The range is from 1 to 4094 (you can use IDs 1 to
4094).
NOTE: This option is available only with the keywordin
option.
in Enter the keyword in to configure the ACL to filter
incoming traffic.
out Enter the keyword out to configure the ACL to filter
outgoing traffic.
NOTE: The option is not available on the S-Series.
NOTE:
1. If the MAC ACL is applied on VLAN, none of the VLAN members should have
an access list applied for that VLAN.
2. If the MAC ACL is applied on a Physical or Port Channel interface, the VLAN
in which this port is associated should not have an access list applied.
3. If the MAC ACL is applied on a VLAN, then that VLAN should not belong to
VLAN ACL group.
4. If the MAC ACL is applied on a VLAN ACL group, then none of the VLANs in
that group should have an access list applied on it.
Defaults none
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
Access Control Lists (ACL)
263