Service Manual

Version Description
8.1.1.0 Introduced on the E-Series ExaScale.
7.8.1.0 Increased the name string to accept up to 140 characters.
Prior to 7.8.1.0, names were up to 16 characters long.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Usage Information The number of entries allowed per ACL is hardware-dependent. For detailed
specification about entries allowed per ACL, refer to your line card documentation.
Prior to 7.8.1.0, names are up to 16 characters long.
Example
Dell(conf)#ip access-list extended TESTListEXTEND
Dell(config-ext-nacl)#
Related
Commands
ip access-list standard — configures a standard IP access list.
show config — displays the current configuration.
permit
To pass IP packets meeting the filter criteria, configure a filter.
Syntax
permit {source mask | any | host ip-address} {destination mask
| any | host ip-address} [count [bytes]] [dscp value] [order]
[fragments] [no-drop]
To remove this filter, you have two choices:
• Use the no seq sequence-number command if you know the filter’s
sequence number.
• Use the no deny {source mask | any | host ip-address}
{destination mask | any | host ip-address} command.
Parameters
source Enter the IP address in dotted decimal format of the
network from which the packet was sent.
mask (OPTIONAL) Enter a network mask in /prefix format (/x) or
A.B.C.D. The mask, when specified in A.B.C.D format, may
be either contiguous or non-contiguous.
any Enter the keyword any to specify that all routes are subject
to the filter.
host ip-address Enter the keyword host then the IP address to specify a
host IP address or hostname.
Access Control Lists (ACL)
249